A water test kit makes testing your water easy. If your inflatable hot tub does not come with such a kit, you can easily find it at any store that carries pool and spa supplies. Once you have tested the water, adjust it using the necessary chemicals. A good pH range for a portable hot tub is between 7.4 and 7.6. A pH that is too low may damage your hot tub’s vinyl and thus damage the tub.
The maximum heat capacity is 104°F, and it uses 120 bubble jets and 4 massage jets to provide an amazing hydro massage. It boasts an impressive 210-gallon water capacity, and it has a flow rate of 460 gallons per hour. It heats the water by 2-3°F per hour. The important features are the easy-to-use digital control panel, the water filtration system, the hard water treatment system, the salt water system, and the comfortably cushioned floor.
Portable or not, an inflatable hot tub still represents a significant investment. Inexpensive models run around $300 or so, and high-end inflatable spas can cost $1000 or more. Before you get ready to spend that kind of money, you should have a pretty good idea of how often you intend on using it. Spending $900 to soak in a hot tub once a month is a poor investment.
First of all, you must make sure that the pH and the alkalinity levels of the water are in check. This is a test that you have to do once per week using a water test kit that either comes with the tub or that you purchase separately from a specialty store. The target level that you should try to maintain is for the water to range in pH from 7.4 to 7.6. Anything higher or lower causes the degradation of the tub, damaging the material that it is constructed from.
Maybe it’s most annoying feature is that it seems to shut off automatically after 72 hours. So you have to reset it every few days. But other than that, it’s fine. It offers the very basic service of an inflatable hot tub, and you get the soothing bubbles as a bonus. The comparatively fast heating system is also a treat, especially with a tub this cheap. It’s one of the best inflatable hot tub models you can get at this price range.
It can accommodate a maximum of 4 people at once. It has a water capacity of 217 gallons, and the rapid heating system is able to raise the temperature of the water by 2-3°F per hour. The maximum heat capability that it features is of 103°F. It comes with 88 air jets that deliver a soothing massage. To ensure that the water in it will be of a great quality and safe to sit in, it features a useful water filtration system.
Conventional tubs are extremely expensive, meaning that they are an impossible investment for most people. On the other hand, inflating models come at considerably lower prices, some even costing one-tenth of the price of a traditional tub. This is an advantage worth taking into consideration because you will not only save a huge amount of money, but you will do this without sacrificing quality at all. Also, the lack of hassle when assembling and installing them is worth taking into account. In addition, the easy installation means that you will save money because you won’t need to hire a plumber or an electrician for this task.
Cover: if you spot a model that includes the cover, it is a plus, however don’t take the cover of an average model as an advantage just because it has a cover. They are quite important to keep your tub not only hotter for longer but also to protect the water from getting contaminated with sitting dust and any other contaminants from the air, from leaves to insects that may be really looking for water. Most brands that don’t include the cover sell it separately.
The main issue against saltwater hot tubs is that salt causes corrosion. At levels of 2,000-3,000 ppm, there should be no worry about damage to finishes and pool equipment. There is one material in particular that doesn’t like salt, that being Buna rubber, which some pump shaft seals are made of. Again, at normal levels, there should be no concern. But if your pump seal begins to leak, we do have pump shaft seal made for high salt or ozone conditions.
Small hot tubs that accommodate two adults and are designed for a more intimate experience measure about 3 to 4 feet high by 5 feet across and hold approximately 500 gallons of water. Larger hot tubs measure around 4 to 5 feet high and 6 feet or more in diameter and are built to accommodate up to 8 adults or more. They hold about 850 gallons of water.
Heating the water up – One must keep in mind that a hot tub can take several hours to heat up depending on its construction and the technologies it employs. Please consider that the bigger the tub is the more it would take for the water inside it to heat up to the desired temperature. Furthermore, black hot tubs kept outdoors will likely draw more sunlight, thus causing the water they contain to heat up much faster.
Maximum Heat Capability It shows what is the maximum temperature that the water can reach. When choosing the products, we made sure that they all feature a maximum heat capacity of around 104°F. This is the ideal temperature for the water to reach, being high enough for the experience of soaking in it to be as pleasant as possible without there being any repercussions. SaluSpa Hawaii HydroJet Pro, Intex 28443E PureSpa Jet & Bubble Deluxe, , Coleman SaluSpa
The design and structure of the tub is just as important as the materials used to make it. Many manufacturers use a segmented inflatable design, reinforced with a vertical I-beam structure inside. These internal vinyl panels make for a sturdier tub, one that can support users leaning against it or even sitting directly on the outer wall of the spa. Premium portable hot tubs add another level of stability and protection with interlocking panels that surround the inflatable tub. Made of waterproof composite materials, these panels provide a rigid wall that protects and insulates the hot tub.
The main issue against saltwater hot tubs is that salt causes corrosion. At levels of 2,000-3,000 ppm, there should be no worry about damage to finishes and pool equipment. There is one material in particular that doesn’t like salt, that being Buna rubber, which some pump shaft seals are made of. Again, at normal levels, there should be no concern. But if your pump seal begins to leak, we do have pump shaft seal made for high salt or ozone conditions.
Apart from the filters and chemicals one should employ to ensure the long-term durability of their inflatable hot tub, you aren’t likely to need any other tools or accessory. Even so, make sure to give it the attention it deserves in regards to cleaning and maintenance. You should also remember to deflate it fully when storing it to avoid any complications. In fact, you can always give the tub a good scrub after you’ve deflated it, just so it will be clear of any impurities that might otherwise damage the tub in the long run.
Since this inflatable tub is smaller, but from the same powerhouse brand, that is Bestway Lay-Z-Spa, you know that you’re getting an incredible value with this product. It is going to have the same patented, 3-ply reinforced TriTech, that guarantees top of the line durability. The Miami is Bestway’s world’s first premium inflatable spa, and it still remains a top choice in the industry.
These Lay-Z-Spas are great for your health and relaxation. Relaxing in one of the hot tubs can help you melt the stress away from a hard days work. Or after you workout at the gym. They help in the recovery of muscle strain while lifting weights. You will recover from lactic acid build-up, this is when your muscles ache the next day or even a few hour after training. Jump into your Lay-Z-Spa as soon as you can will help reduce the lactic acid build-up and you will feel great as well.
×