Measuring 6 feet 4 inches across, the 28-inch deep Lay-Z-Spa holds up to 254 gallons of water. The tub is made of two layers of PVC reinforced with a layer of polyester mesh in between. The tub features vertical beam construction, which adds additional support with vertical vinyl panels inside the inflatable tub wall, and the hot tub will easily support you if you lean against the tub wall. The tub has a synthetic leather exterior in bright Coleman green. The whole package weighs 86 pounds when unfilled, and as portable inflatable hot tubs go, that’s not bad.

Intex’s PureSpa Bubble Massage hot tub is a very spacious tub by pretty much all standards, managing to accommodate up to four people at the same time. It also benefits from a built-in hard water treatment system that makes water more gentle and an insulated cover with a lock to minimize heat loss. At the same time, the tub uses a PureSpa patented heating system, a 3-way test strip, a floating pool chlorine dispenser, a thermal ground cloth, an inflation hose, and two filter cartridges.

We refer to a hot tub as regular when you can install it in your home just like a bathtub. It comes with massage jets and works with hot water just like the ones in spas. A lot has to be done for this hot tub to work. Its because you put in connections like you are installing any other appliance in the home. It is permanent, and you cannot move it without enlisting the services of experts.


Without belaboring the importance of maintaining proper water chemistry, be aware that using your spa without the correct sanitizer levels opens you and other bathers up to several health issues that vary in severity from rashes, such as hot tub folliculitis, to the potentially life-threatening Legionella bacteria that causes Legionnaires’ disease.
Have you ever set in a pre-fabricated hot tub? If so, you’re probably familiar with the built-in bucket seats. Unfortunately, with the inflatable tubs, you’re not going to have built-in seats. However, as we mentioned, the entire tub offers soft cushioning, so in all actuality, while built-in bucket seats would have been nice, it’s really not needed.

The salt cell used for saltwater hot tubs is a titanium coated electrolytic cell, which will eventually lose enough of its coating to stop producing enough chlorine. Spa salt cells usually last 2-5 years, depending on the model. At that point, you can replace just the cell (not the power supply). Keeping your cell clean (some models are self-cleaning), and not using it for cold spa water (below 60° F), are key to a long cell life.


Now let me tell you about the Construction of the Tub. The Technology used to build the tub is TriTech technology. The Miami AirJet is made up of 3 ply mesh core with reinforced polyester. So the Tub is taken care to survive in harsh conditions without getting Punctured. And you also get I Beam Construction. The Spa is made so tough that you can even sit on the walls of the tub without it getting bent.

DoItYourself.com®, founded in 1995, is the leading independent home improvement and repair website. We welcome your comments and suggestions. All information is provided "AS IS." Website operating problems contact [email protected] Questions of a Do It Yourself nature should be submitted to our "DoItYourself.com Community Forums". Copyright © 1995-2019 MH Sub I, LLC dba Internet Brands. All rights reserved. You may freely link to this site, and use it for non-commercial use subject to our terms of use. View our Privacy Policy here.
×